TSLM - M601 Operational & Install Manual
Torque Exceeds
This counter tracks the number of times the TORQUE have exceeded:
M601D 132 psi
M601E-11 145 psi
M601E-11A 134 psi
Max. Unit Temperature ºC
This configuration property informs you of the highest temperature the unit have been exposed to.
It can be reset to begin afresh.
Min. Unit Temperature ºC
This configuration property informs you of the lowest temperature the unit have been exposed to. It
can be reset to begin afresh.
Last Attempted Start Time (seconds)
This value provides feedback about the performance of the last start by telling you how long it took
to go from zero to idle speed.
Last Attempted Start Min Voltage (V)
This value provides feedback about the performance of the last start by telling you what the lowest
bus voltage was during the previous start. The weaker the batteries the lower this value.
Last Attempted Start Max ITT (ºC)
This value provides feedback about the performance of the last start by telling you what the highest
ITT value was during the previous start.
Last Attempted Start EHT Resistance (Ohms)
This value tells you what the measured resistance was of the EHT valve when the last start was
initiated.
ITT Calibration
This configuration property calibrates the ITT measurement.
Voltage Calibration
This configuration property calibrates the voltage measurement.
Torque Span Calibration
This configuration property calibrates the torque measurement.
Torque Offset Calibration
This configuration property calibrates the torque measurement.
Oil Pressure Span Calibration
This configuration property calibrates the oil-pressure measurement.
Oil Pressure Offset Calibration
This configuration property calibrates the oil-pressure measurement.
Oil Temperature Span Calibration
This configuration property calibrates the oil-temperature measurement.
06/29/16 © 2016 VR Avionics page 27 of 33
To Next Page
Loading...