Getting started
6
Squeeze the tabs on the wall mount bracket as indicated by the arrows below.
The wall mount bracket will be released from the tabletop position. Rotate it
downward into wall mount position. Make sure the telephone line cord and power
adapter cord are placed in the cavity in the middle of the wall mount bracket.
Press the wall mount bracket against the telephone base until it clicks into place.
Unplug the telephone cord from the DSL filter if necessary, then route the other
end of the telephone line cord through the cavity.
3.
Plug the telephone line cord back
into the DSL filter or the telephone
wall jack. Plug the power adapter
into an electrical outlet not
controlled by a wall switch.
4.
Align the holes on the wall mount
bracket with the standard wall
mounting plate studs and slide
the telephone down until it locks
securely. Bundle the telephone line
cord and power adapter cord neatly
with twist ties.
5.
Wall mount
bracket
To Next Page
Loading...
Need help?
General
