EasyManuals Logo

VTech CS6449 User Manual

VTech CS6449
87 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #68 background imageLoading...
Page #68 background image
Appendix
64
Expand your telephone system
Your telephone base can support up to 5 handsets. Each handset must be
registered to the telephone base before use.
The handset provided with your telephone system is already registered and
named HANDSET. You can add new handsets (CS6400, purchased separately)
to your telephone base. Additional handsets are assigned numbers in the
sequential order (HANDSET 2, HANDSET 3, HANDSET 4 and HANDSET 5).
Add and register a handset
When rst purchased, each expansion handset alternately
shows 1.Press FIND HS on base 4sec and
2.Then press # on handset. The new handset should be
charged without interruption for at least 30 minutes before
registering it to the telephone base.
To register a handset:
Make sure the handset is out of the handset charger and
is put near the telephone base. Make sure the handset
alternately shows 1.Press FIND HS on base 4sec and
2.Then press # on handset before you begin registration.
Press and hold FIND HANDSET on the telephone base
for about four seconds until the telephone base shows
Registering... Please wait, then release the button.
Press # (pound key) on the handset. The handset
shows Registering... Please wait. It takes up to 60
seconds to complete registration. Then
HANDSET X Registered appears on both screens,
with X being the handset number, and the handset beeps.
The handset is now registered with the
telephone base.
If registration fails, the handset displays Registration failed.
Please start again from Step 1 above.
You cannot register a handset if any other system
handset is in use.
The telephone base shows Registration slots are full
when you try to register more than 5 handsets to it.
If you have not set the date and time for the telephone
system, the handset will prompt you to set the date
and time after it is registered to the base. To skip
setting, press OFF/CANCEL.
1.
2.
3.
2.Then press #
on handset
1.Press FIND HS
on base 4sec
Registering...
Please wait
Registering...
Please wait
HANDSET X
Registered
HANDSET X
Registered

Table of Contents

Other manuals for VTech CS6449

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the VTech CS6449 and is the answer not in the manual?

VTech CS6449 Specifications

General IconGeneral
BrandVTech
ModelCS6449
CategoryCordless Telephone
LanguageEnglish

Related product manuals