Getting started
2
Telephone installation
Install the telephone base and handset charger(s) as shown below.
Make sure that the electrical outlet is not controlled by a wall switch.
If you subscribe to digital subscriber line (DSL) high-speed Internet service
through your telephone line, you must install a DSL filter between the telephone
line cord and the telephone wall jack. The filter prevents noise and caller ID
problems caused by DSL interference. Contact your DSL service provider for
more information about DSL filters.
Telephone
line cord
If you have DSL
high-speed Internet
service, a DSL filter
(not included) is
required.
Telephone base
power adapter
Telephone base Charger
Electrical outlet not
controlled by a wall
switch
Charger
adapter
Telephone
wall jack
This telephone provides minimal functionality during a power outage. When
the AC power is not available, many telephone features do not function. The
telephone uses power from the telephone line to enable you to make and answer
calls using only the corded handset and dialing keys. However, when more than
one telephone on the same line is being used simultaneously, there might not be
sufficient power to operate your telephone in the event of a power failure.
To Next Page
Loading...
Need help?
General
