Getting started
7
Wall mount to tabletop installation
If necessary, untie the bundled telephone line cord and power adapter cord.
Push the telephone base up to remove it from the wall.
Unplug the telephone line cord from the DSL filter or the telephone wall jack
and route it out from the cavity. Unplug the power adapter from the wall outlet.
1.
2.
3.
Pull the wall mount bracket to release it from the wall mount position. Rotate it
upward to tabletop position and then press it against the telephone base until
it clicks into place.
4.
Switch
hook
Handset
tab
Press down the switch hook and slide the handset tab upward to remove it
from the slot. Rotate the handset tab by 180 degrees. Press down the switch
hook and then replace the handset tab to its slot.
5.
See page 2 to complete the telephone installation.6.
To Next Page
Loading...
Need help?
General
