Make a cell call
Press /CELL on the handset. Enter the telephone number, and then press B/CELL to dial. -OR-
Enter the telephone number on the handset, and then press /CELL to dial.
NOTES
After first pressing /CELL, you may need to choose a cell device. Scroll to select the desired cell device when necessary, and then press SELECT.
While using the cell line, place your cell phone closer to the base, and make sure that there are no physical obstacles between the base and the cell phone, such as large
furniture or thick walls.
Answer a home/cell call
Press /HOME, /CELL, , or any dialing key. -OR-
Press ON/OFF key on the headset.
End a home/cell call
Press OFF on the handset, or put the handset in the telephone base or charger. -OR-
Press ON/OFF key on the headset.
Speakerphone
During a call, press on the handset to switch between speakerphone and normal handset use.
Volume
During a call, press /VOLUME/ on the handset, or VOL+ or VOL- on the headset to adjust the listening volume.
NOTE
The handset earpiece volume setting and speakerphone volume setting are independent.
Mute
The mute function allows you to hear the other party but the other party cannot hear you.
1. During a call, press MUTE on the handset. The handset screen displays Muted.
2. Press MUTE again to resume the conversation. The screen displays Microphone on.
-OR-
1. During a call, press MUTE on the headset. The headset announced “Mute on“.
2. Press MUTE again to resume the conversation. The headset announced
“Mute off“.
Join a call in progress
You can use up to two system handsets at a time on a home line call. You can buy additional expansion handsets (DS6072) for this telephone base. You can register up to five
handsets to the telephone base.
When a handset is on a home call, press /HOME or on another handset to join the call.
Press OFF to exit the call. The call continues until all handsets hang up.
Call waiting
When you subscribe to call waiting service from your telephone service provider, you hear an alert tone if there is an incoming call while you are on another call.
Call waiting on the home line:
Press FLASH to put the current call on hold and take the new call.
Press FLASH to switch back and forth between calls.
Call waiting on the cell line:
Press /CELL to put the current call on hold and take the new call.
Press /CELL to switch back and forth between calls.
Find handset
Use this feature to find all system handsets and headsets.
To start paging:
Press FIND HANDSET on the telephone base. All idle handsets and headsets ring and handsets display ** Paging **.
To end paging:
Press FIND HANDSET again on the telephone base. -OR-
Press /HOME, /CELL, , CANCEL, or any dialing key on the handset. -OR-
Place the handset in the telephone base or charger.
NOTE
Do not press and hold FIND HANDSET for more than four seconds. It may lead to handset and headset deregistration.
Redial list
Each handset stores the last 10 telephone numbers dialed. When there are already 10 entries, the oldest entry is deleted to make room for the new entry.
Review the redial list
1. Press REDIAL when the handset is not in use.
2. Press , , or REDIAL repeatedly until the desired entry displays.
Dial a redial list entry
To Next Page
Need help?
Transmit Frequency
