VTech DECT 6.0 User Manual

Once you have installed the battery, the handset LCD display indicates the battery
status (see the table below).
NOTES
Press CANCEL or place the handset in the telephone base or charger will bypass the set date and time, and voice guide.
For best performance, keep the handset in the telephone base or charger when not in use. Place the headset on the telephone base when not in use.
The handset battery is fully charged after 12 hours of continuous charging. The headset battery is fully charged after three hours of continuous charging.
If you place the handset in the telephone base or the charger without plugging in the battery, the screen displays No battery.
Battery indicators Battery status Action
The screen is blank, or shows Put in charger and
flashes.
The battery has no charge or very little charge. The
handset cannot be used.
Charge without interruption (at least 30 minutes).
The screen shows Low battery and flashes.
The battery has enough charge to be used for a short
time.
Charge without interruption (at least 30 minutes).
The screen shows HANDSET X. The battery is charged.
To keep the battery charged, place it in the telephone
base or charger when not in use.
To manually set the date and time and the answering system, refer to Configure your telephone and Set your built-in answering system sections.
To manually initiate the voice guide, refer to Voice guide under Set your built-in answering system section.
Position the headset
There are four earbuds and four earhooks provided. One earbud and one earhook have been attached to the headset.
You can choose a suitable size of earbud, earhook and an appropriate way to position your headset.
Replace the pre-installed earbud and earhook:
1. Hold both sides of the earbud. Twist and pull the earbud until it separates from the earpiece.
2. Rotate the earhook to vertical direction and then pull the earhook until it separates from the headset.
3. Attach a earhook, and then a suitable earbud to the headset until they fit into place. To wear on the right ear:

VTech DECT 6.0 Specifications

Transmit Frequency

DECT frequency	1921.536-1928.448 MHz
Bluetooth frequency	2402.000-2480.000 MHz

Channels

DECT channels	5
Bluetooth channels	79

Power Requirements

Handset battery voltage	2.4V
Telephone base output #1	6V DC @ 450mA
Telephone base output #2	6V DC @ 300mA
Charger output	6V DC @ 400mA