Care & Maintenance
1. Keep
DigiGo™
out of direct sunlight and away from direct sources of heat.
2. Avoid dropping it. NEVER try to dismantle it.
3. Always keep your DigiGo™ away from water.
4. Please examine the toy periodically for conditions that may result in
the risk of fire, electric shock, or injury to persons (such as damage
to the screen, or other parts) and that, in an event of such conditions,
the device should not be used until properly repaired.
5. Examine the power adaptor periodically for conditions that may result
in the risk of fire, electric shock, or injury to persons (such as damage
to the USB cable, pins, housing or other parts). In the event of such
conditions, the adaptor should be replaced.
6. The toy is only to be connected to Class II equipment bearing the
following symbol
).
7. Keep the rubber cover of the micro USB port closed tightly while it
is not in use in order to prevent dust or liquids from getting into the
micro USB port.
Using the Touch Screen and Stylus:
• Use only enough pressure to operate the game. Too much pressure
may damage the touch screen.
• Do not use the stylus if it is broken.
• Do not use any other stylus on the touch screen other than the DigiGo™
stylus.
• Put the stylus back in the stylus holder when not in use.
Cleaning the Touch Screen
• Slightly dampen a soft, lint-free cloth with a little water and wipe the
screen to loosen dirt.
• Using a clean and dry cloth, wipe the screen dry. Repeat these two
steps as needed.
• Pay attention to the small gap around the edge of the LCD screen. Do
not allow any small particles to fall into it.
• If you find small particles in this gap, use a toothpick to gently remove
them.
Cleaning the Cabinet
• Keep your device clean by wiping it with a slightly damp cloth. Never
use solvents or abrasives.
13
To Next Page
Need help?
General
Weight and Dimensions