92
Answering system remote access
You can reach your answering system
remotely by dialing your home telephone
number from any touch-tone telephone.
1. Dial your telephone number from any
touch-tone telephone.
2. Once the system plays your
announcement, enter the two-digit
remote access code (19 is the default
code).
• The system automatically
announces the number of new or
old messages (if any), and then
begins to play them.
You can also enter the following remote
commands.
Commands Description
1 Press to listen to all messages.
2 Press to listen to new messages
only.
3 Press to delete the current
message (during playback).
33 Press twice to delete all old
messages.
4 Press to repeat the current
message (during playback).
44 Press twice to listen to the previous
message.
5 Press to stop.
*5 Press to listen to a list of remote
commands.
6 Press to skip to the next message
(during playback).
*7 Press to record a new
announcement.
8 Press to hang up the call.
0 Press to turn the answering system
on or off.
3. Hang up or press 8 to end the call.
NOTES
• If you do not enter a valid remote
access code, the system answers the
call automatically.
• Once the messages have played, the
telephone announces the help menu
options. If you do not press any key
with 20 seconds, the remote access
call ends automatically.
• If the memory is full, the answering
system answers after 10 rings and
announces, “Memory is full. Enter
the remote access code.” Enter your
remote access code to access the
messages and announcements.
• When the answering system is turned
off, the telephone answers after 10
rings, and announces, “Please enter
your remote access code.”
To Next Page
Loading...
Need help?
General
