93
Call intercept while using answering
system
When a caller is leaving a message on
your answering system, you can stop
recording and talk to the caller by
pressing HOME/FLASH or on
the handset.
Recording memo
1. Press MENU/SELECT in idle mode.
2. Press q CID or p to highlight
Answering sys, then press
MENU/SELECT.
3. Press q CID or p to highlight
Record memo, then press
MENU/SELECT. The system
announces, “Record after the tone.
Press 5 when you are done.” Speak
towards the handset microphone.
4. Press 5 to stop recording. The system
announces, “Recorded.” and then
returns to the previous menu. The
system does not save memos shorter
than two seconds.
Turn on or off the call screening
Use this feature to choose whether
incoming messages can be heard over
the telephone base when they are being
recorded. If you turn call screening on,
you hear the incoming message.
1. Press MENU/SELECT in idle mode.
2. Press q CID or p to highlight
Answering sys, then press
MENU/SELECT .
3. Press q CID or p to highlight Ans
sys setup, then press MENU/SELECT
twice to select Call screening.
4. Press q CID or p to choose
between On and Off, then press
MENU/SELECTto save.
Screen a call with answering system
Screen calls at the cordless handset
If the answering system is on and a call
is being answered by the answering
system, the handset shows To screen
call press [SELECT] at the same time.
Press MENU/SELECT to screen the call
on your handset. The handset shows
the caller’s information. If you do not
subscribe to caller ID service, the
handset shows Screening....
Options while a message is being
recorded
• Press p/VOLUME/q on the handset
to adjust the call screening volume.
To Next Page
Loading...
Need help?
General
