94
• Press to switch between
speakerphone mode and handset
mode.
• Press HOME/FLASH to answer the
call.
Screen calls at the base
If the answering system and call screening
are on, the announcement and the
incoming
message broadcast at the telephone
base when a call is answered by the
answering system.
Options while a message is being
recorded
• Press - VOL + on the telephone base
to adjust the call screening volume.
• Press /PLAY/STOP to temporarily
turn on the call screening if the call
screening is set to off.
Annoucement
Default announcement
The telephone is preset with a greeting
that answers calls with “Hello, please
leave a message after the tone.” You
can use this preset announcement, or
replace it with your own.
Record your own announcement
The announcement can be up to 90
seconds in length.
1. Press MENU/SELECT when the phone
is not in use.
2. Press q CID or p to scroll to
Answering sys, and then press
MENU/SELECT to select.
3. Press MENU/SELECT again to choose
Announcement.
4. The screen displays Play [2] Del [3] Rec
[7] and it announces, “To play, press 2.
To record, press 7.” Press 7 to record.
The phone announces, “Record after
the tone. Press 5 when you are done.”
5. After the tone, speak towards the
microphone. Press 5 when you
are done. The newly recorded
announcement automatically plays.
To listen to the recorded announcement
again, wait after playback has completed,
then press 2.
To Next Page
Loading...
Need help?
General
