38
Additional Information
Wall Mount (Optional)
Notes:
• Check for reception strength and camera angle of the baby unit before drilling the holes.
• The types of screws and plugs you need depend on the composition of the wall. You may
need to purchase the screws and plugs separately to mount your baby units.
1�
Place the wall mount bracket on a wall and then use a pencil to mark two holes
in parallel. Remove the wall mount bracket and drill two holes in the wall (7/32
inch drill bit).
2�
If you drill the holes into a stud, go to step 3.
If you drill the holes into an object other than a stud, insert the wall plugs into
the holes. Tap gently on the ends with a hammer until the wall plugs are ush
with the wall.
To Next Page
Loading...
