22
23
Basic Operation
Basic Operation
Audible Indicators
Your t 2453 telephone system gives you voice prompts for feature opera-
tions and voice confirmations when you press a button or complete an op-
eration.
Setting the clock
1. Make sure the answering system is on.
2. Press TIME/SET. The system announces the clock setting, then an-
nounces: “To Set Day and Time, press TIME/SET.”
3. Press TIME/SET.
4. Press CHANGE until the system announces the correct day, then press
TIME/SET.
5. Press CHANGE until the system announces the correct hour, then
press TIME/SET.
6. Press CHANGE until the system announces the correct minute, then
press TIME/SET. The system announces the current clock setting.
NOTE:
The time will be set automatically with incoming caller ID date. you can however
choose to set the time manually, caller ID is a subscreption service provided by
most telepnohe companies.
To advance the minutes or years by increments of 10, press and hold CHANGE.
About Mailboxes
This answering system has three voice mailboxes. Callers using a touch tone
phone can select the mailbox in which their messages will be recorded
by pressing 1, 2 or 3. Otherwise, messages will be recorded in Mailbox 1.
About Announcements
• You can record two different announcements — one for normal answering
and one for when you’ve set the system to play the announcement only.
• Use normal answering when you want the system to record callers’
messages. Use Announce Only when you want to give information to
callers without accepting messages.
• If you choose not to record an announcement, the system answers with a
pre-recorded announcement.
• The normal answering pre-recorded announcement says: “Hello. I’m unable to
answer your call right now. Please leave your name, number and a
message after the tone.” The Announce Only pre-recorded
announcement says: “Hello, I’m unable to answer your call right now. Please
call again. Thank you.”
• By setting Announce Only to ON or OFF, you decide which announcement your
callers will hear when the system answers a call (the system comes set for
normal answering , with Announce Only turned off). See Set Announce
Only , located in the Feature Summary chart later in this section, to change
your announcement selection.
Answering System Operation At The Base
Screen Displays: When:
PRIVATE The other party is blocking name and/or number
information.
UNKNOWN Your phone company is unable to receive
information about this caller’s name and/or number.
* *
* *
* (after the name) This caller has called you more than once.
Caller ID Operation
Display Screen Messages
To Next Page
Loading...
