VTech t 2453 - Telephone Operation; Make a Call; Answer a Call; End a Call

10
11
Basic Operation Basic Operation
In Use/Charging
•Flashes in unison with inbound calls.
•Flashes slowly when the handset is in use.
•Flashes rapidly when a call is on hold.
•Glows steadily when the handset is charging.
Page
Press to page the handset for up to
60 seconds. Press again, or press OFF
on handset, or place handset in base
to cancel the page.
Telephone Operation
Telephone Operation
End a Call
Press OFF.
-OR-
Place handset
in it base.
Exit
Programming
Cancel a Page
Channel
Switch to a clear channel
while on a call.
Delete
While handset is in idle mode,
press and hold to delete all
records in the call log.
When viewing the call log,
press to delete the current
record displayed.
Handset Volume
Adjust the volume
while on a call. A
double beep will
sound when you
reach the maximum or
minimum setting.
Select
Use SELECT in con-
junction with PROG
during handset pro-
gramming.
Hold
Press to put a call
on hold. Press again
to release hold.
-OR-
Use the extension
phone to pick up the
call.
Answer a Call
Press any key
except OFF.
Flash/Call Waiting
Access special
telephone company
subscriber services.
During a call, press to
receive
an incoming call, if call
waiting is activated.
Make a Call
Press PHONE, then dial
the number.
-OR-
Dial the number (use
to backspace and make
corrections), then press
PHONE to call.
Program
Enter programming
mode with handset
idle (on hook).
Redial
Press PHONE, then press RE-
DIAL/PAUSE to call the the last
number dialed (up to 32 dig-
its).
-OR-
Press REDIAL/PAUSE, then
press PHONE to call the last
number dialed.
Press REDIAL/PAUSE twice to
delete the last number dialed.
Pause
Press REDIAL/PAUSE to inset
a pause when entering num-
bers.
Handset Operation