6
7
Getting Started
Getting Started
3. Attach belt clip to the cordless handset (optional).
Table/Desk Installation
To attach
Standard
electrical outlet
Modular
telephone
jack
After charging the battery for
at least 12 hours, connect the
telephone line cord.
Connect the power cord.
To remove
Installation
NOTE: Install the base unit away from
electronic equipment such as personal
computers, television sets or micro-
wave ovens. Avoid excessive heat,
cold, dust or moisture.
Before You Install
1. Choose a location for the base near an electrical outlet and a
telephone jack. This phone requires a modular telephone jack and a stan-
dard electrical outlet (110v AC) not controlled by a wall switch.
2. Install the handset battery. Use only the provided VTech battery, or
equivalent.
Installation
a) Remove battery
compartment cover
by pressing on the
indentation and
sliding downward.
b) Align the two holes in the plug with
the socket pins, then snap the plug
into place.
c) Place the battery in the compartment
with the wires in the lower right corner.
Angle the top of the battery under the
top claws first, then snap the bottom of
the battery in. Place the wires under the
guide, located below the battery.
d) Replace cover by sliding it up into
e) If the battery is not already charged, please the handset in its
base when not in use to ensure maximum daily performance.
To Next Page
Loading...
