- 4 -
1. GENERAL INFORMATION
1.1. INTENDED USE
B2 series balances are designed to provide accurate measurement of weighed loads, performed
under laboratory conditions. It is intended for application as a non-automatic weighing instrument
only, i.e. the material to be weighed is manually and carefully placed in the center of the weighing
pan. Weighing result should be read only after stable reading has been obtained.
1.2. INAPPROPRIATE USE
Do not use the balance for a dynamic weighing. Even if small quantities of weighed material are
added or removed from the weighing pan of the instrument, the reading should be taken only after
stabilization of the measurement results. Do not place any magnetic materials on the weighing pan,
as this can cause damage to the measuring system of the instrument.
Be sure to avoid impact shock and overloading the balance in excess of the prescribed maximum
measuring range (max capacity), minus any possible tare weight that has been applied.
Never use the balance in an environment where explosion is possible. This balance has not been
adjusted for operation in explosive areas.
There must not be any modification made to the balance.
1.3. WARRANTY
Warranty is invalid for the following:
• non-observation of the guidelines of this user manual,
• use of the balance other than specified in this manual,
• alteration to or opening of the device,
• overloading of the measuring instrument.
2. UNPACKING AND INSTALLATION
2.1. STANDARD DELIVERY COMPONETS LIST
• Balance and components shown in Section 2.4 depending on balance model
• Warranty Card
• User Manual
2.2. UNPACKING
To unpack the system, follow the diagram below-
To Next Page
Loading...
