EasyManua.ls Logo

VWR B2 Series - Page 55

VWR B2 Series
56 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- 55 -
Remove the back pane.
Remove side panes.
Side panes shall not be swapped
therefore it is necessary to remember
which one is right, and which one is left
in order to install them back properly.
CAUTION! Do not remove the front pane!
Remove a weighing pan, a draft shield,
a bottom insert. Clean the components
when detached. With this your balance
mechanism is protected against
accidental damage.
Draft shield and panes now can be properly cleaned. All the operations should be done carefully. Pay
special CAUTION to the spot where the weighing pan was installed: dirt and other small elements
might enter the balance construction through this opening, which might negatively influence the
balance parameters.

Table of Contents

Related product manuals