24 VWR Mega Star 600 / 600R ver b, rel 17.07.2020
Programs
The VWR Mega Star 600 Centrifuge is able to save up to 4 programs; the VWR Mega Star 600R is able to
save up to 99 programs. It is only possible to save a program if the centrifuge is in standstill.
Loading or saving of programs is not possible if the centrifuge is spinning.
Saving a Program
Modify the speed, time and temperature to the desired setting.
For Direct Access Programs 1, 2, 3
Press and hold the desired program key 1, 2 or 3 for 4 seconds.
For Programs 4-99
1. Press the folder key for 4 seconds. Use the SPEED arrow keys, to scroll through until the desired
number is selected.
2. Press the START key to confirm.
3. The program can now be named using up to 12 alphanumeric characters. Use the SPEED arrow
keys to scroll through the characters. Use the TIME arrow keys to move left or right.
4. Press the START key to confirm and save the program.
To abort at any point, press the STOP key.
Selecting a Program
For Direct Access Programs 1, 2, 3
Press one of the direct access program keys 1, 2, 3.
For Programs 4-99
Press the folder key. Use the SPEED arrow keys to scroll through until the desired program is selected.
Centrifugation
Maximum Loading
WARNING Injuries with fatal consequences can occur when using substance mixtures with a
higher density than 1.2
at maximum speed.
Rotors can run at high speeds. Each rotor is specifically designed to run at its maximum speed with a
defined load. For further details refer to the rotor manual supplied with the rotor.
The rotors are designed to work with substance mixtures with a density of up to 1.2 g/ml. Above this density
or if total load is above the maximum weight the following steps should be taken:
• Reduce the fill level.
• Reduce the speed.
To Next Page
Loading...
