IMPORTANT: Only use the mains adapter supplied (36-PSU1012
12V DC 2.5A) The adapter contains a transformer. Do not cut
off the adapter to replace it with another plug as this causes a
hazardous situation.
• The adapter transforms the mains voltage (100-240 Volts) to a
safe voltage (12V DC)
• Make sure the adapter does not get wet
• Do not use a damaged adapter
• Always unplug your MicroLab before cleaning
WARNING: Do not connect devices that are not specied as part
of the system.
Note: If an MPSO (Multiple Portable Socket Outlet) is used with
the system, the maximum permitted load should not be exceeded.
Do not connect electrical equipment that has not been supplied as
part of the system.
88
To Next Page
Loading...
