11 Appendix IV
119
WABCO Maintenance Manual MM-0112 (Revised 07-18)
Figure 11.23
Figure 11.23
SID SPN FMI
Warning
Light
Programming
Error Code
Message
Displayed
Description/Action
253 630 2 ABS WL A1
Error parsing the Aftermarket
Programming configuration file
(Error: A1).
Close the TOOLBOX™ Software, reopen it and restart the aftermarket programming
application. If the problem persists, repeat with key on only (Engine Off).
253 630 2 ABS WL A2
No parameters were found in the
Aftermarket Programming configuration
file (Error: A2).
Close the TOOLBOX™ Software, reopen it and restart the aftermarket programming
application. If the problem persists, repeat with key on only (Engine Off).
253 630 2 ABS WL A3
Part number is missing from the
Aftermarket Programming configuration
file (Error: A4). Please contact WaBCO
North America Customer Care at
855-228-3203.
Close the TOOLBOX™ Software, reopen it and restart the aftermarket programming
application. If the problem persists, repeat with key on only (Engine Off).
253 630 2 ABS WL A4
VIN not found in the Aftermarket
Programming configuration file (Error:
A4). Please contact WABCO North
America Customer Care at
855-228-3203.
Close the TOOLBOX™ Software, reopen it and restart the aftermarket programming
application. If the problem persists, repeat with key on only (Engine Off).
253 630 2 ABS WL C1
Mismatch found between installed ECU
and the configuration file (Error: C1).
Close the TOOLBOX™ Software, reopen it and restart the aftermarket programming
application. If the problem persists, repeat with key on only (Engine Off).
253 630 2 ABS WL C2
[Parameter] Incorrect for installed ECU
part number (Error: C2).
Close the TOOLBOX™ Software, reopen it and restart the aftermarket programming
application. If the problem persists, repeat with key on only (Engine Off).
4012095a
To Next Page
Loading...
