WABCO TAILGUARD - Planning and Performing TailGUARD Installation; Installation Planning and Parameter Setup

38
Planning and performing the TailGUARD™ installation
Planning and performing the TailGUARD™ installation
9 Planning and performing the TailGUARD™
installation
TheinstallationofTailGUARD™shouldbeplannedinadvancewiththeaidofachecklistprovidedbyWABCO.This
checklistcanbefoundinSection11.3ofthesystemdescriptionforTailGUARD™forTruck&Bus.
Based on
 theinformationgiveninthechecklist,
 informativephotographs,inparticularoftheliftingandtippingmechanismoftherespectiverefusecollection
vehicle,
 aswellasthemeasurementsfortheintendedpositionsoftheultrasonicsensors,
WABCOpreparesanindividualsetofparametersforTailGUARD™thatcanbeloadedintotheElectronicExtension
ModuleusingtheTEBSEDiagnosticSoftware.
TobeabletowritethissetofparameterstotheECU,aPIN2isrequiredasaccessauthorisationforthisprotected
function.
APIN2authorisationcanbeacquiredbytakingthetwoe-learningcourses
 "TrailerEBSE"(WABCOproductnumber:2003001040)and
 "TrailerEBSE1toE2"(WABCOpartnumber:2003001140)
andcompletingthemsuccessfully.