EasyManua.ls Logo

Wacker Neuson BH 55 - Maintenance

Wacker Neuson BH 55
54 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3 Safety
100_0302_si_0001.fm 14
3.15.4 Health hazard due to exhaust fumes
Warning
The engine's exhaust fumes contain chemicals which are known to the State of California to cause
cancer, congenital defects or other reproductive anomalies.
3.15.5 Notes on the EPA engine
3.16 Maintenance
Maintenance work
Service and maintenance work must only be carried out to the extent described in these operating
instructions. All other procedures must be performed by your Wacker Neuson representative.
For further information, refer to chapter Maintenance.
Switching off the engine
Before carrying out care or maintenance work, switch off the engine and allow it to cool down.
For gasoline powered engines, you must pull off the spark plug cap.
Handling operating fluids safely
Observe the following points when handling operating fluids, e.g. fuels, oils, greases, coolants etc.:
Always wear personal safety clothing.
Avoid skin and eye contact with operating fluids.
Do not inhale or swallow operating fluids.
In particular, avoid contact with hot operating fluids. Burn and scalding hazard.
Dispose of replaced or spilled operating fluids according to the applicable regulations for
environmental protection.
If operating fluids escape from the machine, cease operation of the machine and have it repaired
immediately by your Wacker Neuson representative.
Cleaning
Always keep the machine clean and be sure to clean it each time you have finished using it.
Do not use gasoline or solvents. Danger of explosion!
Do not use high pressure washers. Permeating water can damage the machine. When electrical
equipment is present, this can pose a serious injury risk from electric shocks.
Cleaning the zerk fitting
Wipe the zerk fitting with a clean cloth after the lubrication of the machine. There is a danger of
electrocution if there is excessive grease on the zerk fitting.
CAUTION
This machine is equipped with an EPA-certified engine.
Modifying the motor speed influences the EPA certification and emission. The motor may
only be set by a skilled technician.
For more detailed information, contact your nearest motor or Wacker Neuson
representative.

Table of Contents

Related product manuals