7 Transport
21 100_0302_tr_0001.fm
7 Transport
Performing preparations
1. Switch off the engine.
2. Remove tool.
3. Lean the machine upright against a solid object and secure it to prevent it from toppling over.
Wacker Neuson recommends to hang the machine on the truck.
4. Let machine cool off.
Emptying the fuel system
The fuel system must be empty during transport in order to prevent fuel from escaping through the
pressure relief valve.
1. Remove any dirt around the fuel cap.
2. Unscrew and remove fuel cap.
3. Pump the fuel out into a suitable container or tank, e.g. with a suction pump.
4. Position the fuel cap and tighten it.
5. Start the engine and let it idle until the fuel in the carburetor is used up and the engine stops.
Transporting the machine
1. Lift machine with the supplementary handle.
2. Place the machine on or into a suitable means of transport.
3. Secure the machine against falling over and down or sliding.
WARNING
Improper handling can result in injury or serious material damage.
Read and follow all safety instructions of this operator's manual, see chapter Safety.
WARNING
Danger of fire and explosions by fuel.
Any fuel that escapes can ignite and cause severe burns.
Lift and move the machine in the upright position.
NOTICE
The fuel cap has a pressure relief and vacuum valve through which fuel can escape when
it is warm (e.g. in direct sunlight).
NOTICE
Wacker Neuson recommends to use the truck for the transport on the construction site,
refer to chapter Accessories.
To Next Page
Loading...
