9 Use and operation
23 100_0302_op_0001.fm
9 Use and operation
9.1 Prior to starting the machine
Checking the machine
Check the following points before beginning work:
Damage to the machine and to all components.
If the machine is damaged, do not start the machine. Have any damage or defects eliminated
immediately.
Fuel level, see chapter Maintenance.
Air cleaner, see chapter Maintenance.
Recoil starter, see chapter Maintenance.
9.2 Adjusting the machine
Machine with integrated shut-off device – RS (optional)
The machine only works when either the plug of the remote cut-off or the shorting plug is plugged in at
the connection socket of the integrated shut-off device.
9.3 Operation with remote cut-off
If you wish to operate the machine via an external remote cut-off:
1. Remove the shorting plug from the connection socket.
2. Plug the shorting plug into the handle opposite so that it does not get lost.
The machine is now ready for operation with the remote cut-off. For further information, see the
remote cut-off operator's manual.
9.4 Operation without remote cut-off
If you wish to operate the machine without an external remote cut-off:
1. Remove the shorting plug from the handle opposite.
2. Plug the shorting plug into the connection socket.
The machine is now ready for operation with the remote cut-off.
WARNING
Improper handling can result in injury or serious material damage.
Read and follow all safety instructions of this operator's manual, see chapter Safety.
Item Designation Item Designation
1 Shorting plug 3 Handle
2 Shorting plug
To Next Page
Loading...
