Wacker Neuson BH 55 - Exclusion of liability; Operators manual; Country-specific regulations; Operators controls

3 Safety
9 100_0302_si_0001.fm
Maintenance
Regular maintenance is required in order for the machine to operate properly and reliably over time.
Failure to perform adequate maintenance reduces the safety of the machine.
 Strictly observe the prescribed maintenance intervals.
 Do not use the machine if it requires maintenance or repairs.
Malfunctions
If you detect a malfunction, you must shut down and secure the machine immediately.
Eliminate the malfunctions that impair safety immediately!
Have damaged or defective components replaced immediately!
For further information, refer to chapter Malfunctions.
Spare parts, accessories
Use only spare parts from Wacker Neuson or such that are equivalent to the original parts in design and
quality.
Only use accessories from Wacker Neuson.
Non-compliance will exempt the manufacturer from all liability.
3.5 Exclusion of liability
Wacker Neuson will refuse to accept liability for injuries to persons or for damage to materials in the
following cases:
 Structural modifications.
 Improper use.
 Failure to comply with this operator's manual.
 Improper handling.
 Using of spare parts which are not from Wacker Neuson and not equivalent to the original parts in
design and quality.
 Using of accessories which are not from Wacker Neuson.
3.6 Operator's manual
Always keep the operator's manual near the machine or near the worksite for quick reference.
If you have misplaced the operator's manual or require an additional copy, contact your Wacker Neuson
representative or download the operator's manual from the Internet (www.wackerneuson.com).
Always hand over this operator's manual to other operators or to the future owner of the machine.
3.7 Country-specific regulations
Observe the country-specific regulations, standards and guidelines in reference to accident prevention
and environmental safety, for example those pertaining to hazardous materials and wearing protective
gear.
Complement the operator's manual with additional instructions taking into account the operational,
regulatory, national or generally applicable safety guidelines.
3.8 Operator's controls
Always keep the operator's controls of the machine dry, clean and free of oil or grease.
Operating elements such as ON/OFF switch, gas handles etc. may not be locked, manipulated or
changed without authorization.
Checking for signs of damage
Inspect the machine when it is switched off for any signs of damage at least once per work shift.
Do not operate the machine if there is visible damage or defects.
Have any damage or defects eliminated immediately.
Supervision
Never leave the machine running unattended!