11 Malfunctions
100_0302_ts_0001.fm 34
11 Malfunctions
Potential faults, their causes and remedies can be found in the following table.
Notify your Wacker Neuson contact in case of malfunctions you cannot or may not remedy yourself.
Malfunction Cause Remedy
Engine does not start. Fuel tap is closed. Open the fuel tap.
Fuel tank is empty. Top up with fuel.
Fuel line is clogged. Have the fuel line cleaned.*
Fuel filter is clogged. Have the fuel filter replaces.*
Carburetor is clogged. Have the carburetor cleaned.*
Air cleaner is clogged. Clean air cleaner.
Spark plug cap is defective. Have the machine repaired.*
Spark plug is defective. Change the spark plug.
Spark plug is loose. Tighten the spark plug.
Spark plug gap is set incorrectly. Set the spark plug gap.
The connection socket of the
remote cut-off is empty.
Connect remote cut-off.
Insert shorting plug.
Remote cut-off is not functioning
properly.
Check remote cut-off according to
the manufacturer's instructions.
Engine shuts off right after starting. Fuel tank is empty. Top up with fuel.
Fuel filter is clogged. Have the fuel filter replaces.*
Air cleaner is dirty. Clean or replace air cleaner.
Engine has low performance. Air cleaner is dirty. Clean or replace air cleaner.
Recoil starter defective. Starter rope jammed. Have the starter rope replaced.*
Starter rope torn off.
*
Have these tasks carried out by the service department of your Wacker Neuson contact person.
To Next Page
Loading...
