Commissioning
Tests before commissioning 7.2
Ground conditions
The maximum dumping height depends on several factors of the ground
conditions. An exact specification of this value is not possible.
▪ Determine the maximum fill height by compaction tests or soil sam-
ples.
Shaking in cobblestones
▪ To avoid damage to the machine or compaction material, use a slid-
ing device, see Accessories on page 46.
Compaction of asphalt
▪ To avoid cracking and sticking to the asphalt, use water tank with
sprinkler system, see Accessories on page 46.
7.2 Tests before commissioning
Information
Further information and detailed descriptions, see Mainte-
nance on page 37.
Perform the following checks:
• Check machine and components for damage.
– Do not put the damaged machine into operation. Damages and
defects must be repaired immediately.
• Check the fuel level.
• Check fuel lines for leaks.
• Check air filter.
• Check engine oil fill level.
• Check to ensure the screw connections are firmly seated.
• Check control elements for functionality.
7.3 Putting into operation with Briggs & Stratton engine
WARNING
Danger of burns due to starting aid sprays!
Starting aid sprays can ignite and cause severe burns.
► Do not use any starting aid sprays.
[en-US] | Version: 5 | 04/2023 | 5100066824 | BPS1030B, BPS1135B, BPS1340B, BPS1550B, BPS2050B | BPS |
Operator’s Manual 33
7
To Next Page
Loading...
