Commissioning
Tests before commissioning 7.2
29
[en] | 07/2022 | 5100056271 | BS-2 | Operator’s Manual
CAUTION
Risk of injury and material damage due to recoil!
On firm, hard or unyielding floors, injuries and material damage may res-
ult from strong rebounds.
► Avoid hard or unyielding floors.
CAUTION
Risk of collapse and spillage!
There is a risk of injury from falling or spilling when working on fracture,
pit, dump and embankment edges, on trench edges and heels.
► Pay attention to side walls and their stability.
► Ensure stability.
7.2 Tests before commissioning
Information
Further information and detailed descriptions, see Maintenance on
page 33.
Perform the following checks:
• Check machine and components for damage.
– Do not put the damaged machine into operation. Damages and
defects must be repaired immediately.
• Check the fuel level.
• Check engine oil fill level.
• Check to ensure the screw connections are firmly seated.
• Check control elements for functionality.
• Check the air intake area for dirt.
7.3 Putting into operation
CAUTION
Hot exhaust!
Contact may cause burns.
► Only operate the machine if the safety features are correctly fitted.
► Do not change or remove safety devices.
7
To Next Page
Loading...
Need help?
General
