BTS 630, 635 9 Use and operation
Operator's manual 41
9 Use and operation
9.1 Prior to starting the machine
9.1.1 Checks before startup
Checking the machine
Always check the following points before beginning work:
Damage to the machine and to all components.
If the machine is damaged, do not start the machine. Have any damage or
defects eliminated immediately.
Damage to the cutting blade (cracks, sections broken off, deformation, off
balance, etc.)
Fuel level, see chapter Maintenance.
V-belt tension, see chapter Maintenance.
Tightness of the protective hood.
9.1.2 Changing the cutting blade
Performing preparations
1. Place the machine upright on a flat surface.
2. Set the multifunction switch to Stop.
WARNING
Improper handling can result in injury or serious material damage.
f Read and follow all safety information of this operator's manual, see chapter
Safety.
To Next Page
Loading...
Need help?
General
