BTS 630, 635 13 Storage
Operator's manual 69
13 Storage
If the machine will not be operated for a while, e.g. during the winter, do the
following:
Performing preparations
1. Switch off the engine.
2. Detach the cutting blade and store in a dry place.
3. Let the machine cool off.
Emptying the fuel system
The gasoline in the fuel partially evaporates during long-term storage. The two-
cycle oil in the fuel does not evaporate. After long-term storage the mixture ratio
of gasoline to two-cycle oil is no longer correct. For this reason, the fuel system
must be be empty for long-term storage.
1. Remove any dirt around the fuel cap.
2. Slowly unscrew and remove the fuel cap.
3. Pump the fuel out into a suitable container or tank, e.g. with a suction pump.
4. Position the fuel cap and tighten it.
5. Start the engine and let it idle until the fuel in the carburetor is used up and
the engine stops.
Storing the machine
1. Clean the machine.
2. Store the machine in a dry place.
To Next Page
Loading...
Need help?
General
