BTS 630, 635 10 Maintenance
Operator's manual 63
10.3.9 Setting the idle speed
1. Start the engine.
2. Allow the engine to warm up.
3. Set the idle speed with a screwdriver:
If the cutting blade rotates in idle, turn the adjusting screw for idle speed
counter-clockwise until the cutting blade stops.
If the engine shuts off in idle, turn the adjusting screw a bit clockwise.
Note: If the cutting blade still rotates after setting the idle speed, have it repaired
by your Wacker Neuson representative.
Item Designation
1 Adjusting screw
To Next Page
Loading...
