5-42 BA ET16 de* 1.0 * et16b510.fm
5 Operation
Setting down
Crushing hazard when attachments are removed!
If an attachment is not removed correctly, it can tip over and cause serious
injury or death.
► Do not allow anyone to stay in the danger zone.
► Lower the attachment to level and firm ground ensuring stability.
► Only remove the pins from the attachment if it is in a stable position.
► Lower the attachment to the ground without too much pressure,
otherwise the resistance is too high when the pins are removed.
Re-equipping the attachments is described below for a bucket.
Follow the special information when fitting or removing attachments with
their own hydraulic functions (for example an offset bucket). Observe the
Operator’s Manual of the attachment.
The hydraulic system of the machine is still pressurized even when the
engine is not running. Due to the residual pressure, the hydraulic quick
couplers can be removed but not installed back on again.
► Release the pressure.
To Next Page
Loading...
