4-40 BA E19 en* 1.0 * E19_10_400.fm
4 Putting into operation
Functional check of the joystick base
Before starting work, perform a functional check of the control lever base.
1. Start the vehicle.
2. Fold the control lever base G down.
3. Perform vehicle travel on open terrain.
4. Secure the danger zone.
5. Stop the vehicle.
6. Raise the control lever base G.
7. Move all control levers and pedals in all directions.
➥ The selected elements do not move:
➥ Work may be performed with the vehicle.
➥ The selected elements move:
➥ Stop operation immediately.
Contact a Wacker Neuson service center and have the malfunction
rectified.
Possible damage if the engine is started again immediately after stopping
it.
► Wait at least two minutes before starting the engine again.
Possible damage to preheater if the preheating system is operated too
long.
► Do not preheat the engine for more than 20 seconds.
To Next Page
Loading...
