Wacker Neuson ET42

BA E19 en* 1.0 * E19_10_510.fm 5-35
Operation 5
Functional check of safe load indicator
Always perform a functional check of the safe load indicator before
performing lifting gear applications.
1. Start the vehicle.
2. Perform vehicle travel on open terrain.
3. Secure the danger zone.
4. Stop the vehicle.
5. Switch on the safe load indicator.
6. Raise the boom as far as it will go and hold the control lever in this
position.
Perform a functional check of the joystick base.
– see chapter “ Functional check of the joystick base” on page 4-40
Only the following lifting gear may be used for lifting gear applications:
• Powertilt/quickhitch with load hook
• Joint rod with lifting eye
When symbol A is displayed and the buzzer sounds:
• Reduce the load until the buzzer goes out and the symbol disappears.
Suitable equipment for fastening and securing loads must be available.
Fig. 168
A
Warning devices Result
The buzzer sounds and sym-
bol A is displayed
The vehicle may be used for lifting gear
applications.
Buzzer does not sound or
symbol A is not displayed
The vehicle may not be used for lifting
gear applications. Contact a
Wacker Neuson service center.
Fig. 169
Fig. 170
A