BA E19 en* 1.0 * E19_10_400.fm 4-11
Putting into operation 4
Seat belt
Injury hazard if the seat belt is not fastened correctly or not at all!
Fastening the seat belt incorrectly, or not at all, can cause serious injury or
death.
► Firmly fasten your seat belt over your hips before starting the engine.
► Do not loosen the seat belt while the engine is running. This also
applies to the work interruptions.
► Do not fasten a twisted seat belt, and do not place it over hard, edged
or fragile items in your clothes.
► Ensure that the buckle is inserted.
Injury hazard due to damaged or dirty seat belt!
A damaged or dirty seat belt can cause serious injury or death.
► Keep the seat belt and buckle clean, and check them for damage.
► Have a damaged seat belt and buckle immediately replaced by an
authorized service center.
► After every accident, have the seat belt replaced immediately by a
Wacker Neuson service center and have the anchor points and the
seat attachment checked for additional strength.
Fastening the seat belt
Insert buckle latch A into seat belt buckle B until it locks into place.
Unfastening the seat belt
Press the push button switch C on buckle B until the buckle latch comes
out.
The seat belt is automatically retracted.
Fig. 90 (symbolic representation)
A
B
C
To Next Page
Loading...
