Labels LTN
26 wc_si000705gb.fm
N
See Operator’s Manual for metal halide lamp
information and troubleshooting.
BEFORE STARTING THE ENGINE:
1. Check levels of
Engine oil
Fuel
Coolant
2. Move the circuit breakers to the OFF
position.
TO START THE ENGINE:
1. On the engine control panel, turn the key
switch to the PREHEAT position; the
indicator light will illuminate during
preheating.
2. When the PREHEAT indicator light goes
out, turn the key switch to the START
position for a maximum of 15 seconds.
3. When the engine is running, move the
circuit breakers to the ON position.
TO SHUT DOWN THE MACHINE:
Move the circuit breakers to the OFF
position.
Turn the key switch to the OFF
position to stop the engine.
O
WARNING
Operation of this equipment may create
sparks that can start fires around dry vegeta-
tion. A spark arrester may be required. The
operator should contact local fire agencies
for laws or regulations relating to fire preven-
tion requirements.
P
WARNING
Crushing hazards.
Stand clear of front and rear of machine
when tower is being raised or lowered.
To Next Page
Loading...
