wc_tx004431gb_FM10.fm
69
LTV Operation
3. Press “Auto” to enter the selected editor.
Note: If a PIN code has been set for the Configuration Editor, the PIN request
appears.
4. Press the up and down arrows to adjust first digit to the correct value.
5. Press the “Start” button (e) when the first digit is correctly entered. The digit
changes to # for security purposes.
6. Enter each of the digits of the PIN number. Press “Stop” to move back to adjust
one of the previous digits.
7. After entering the last digit, press “Auto” to validate the PIN code. If the number
is not correct, the editor is exited.
Note: Press and hold “Stop” or “Start” to enable the auto-repeat functionality.
8. Once in the selected editor, press the up and down arrows to cycle through it in
increments of 100. Press “Stop” or “Start” to cycle through the editor in
increments of 1. The table below lists the parameters needed to configure a
schedule.
9. To select a parameter to edit, press “Auto.” The parameter value flashes.
10.Press “Stop” or “Start” to adjust the value to the required setting.
11.Press “Auto” the save the current value. The value stops flashing.
Note: For security purposes, the editor automatically exits after 5 minutes of
inactivity.
12.To save and exit the editor, press and hold “Auto.” To exit without saving, press
and hold “Stop.”
Configuration Parameters – Scheduler
901 Enable Scheduler On (1), Off (0)
902 Schedule Run On or Off Load On (1), Off (0)
903 Schedule Period Weekly (0), Monthly (1)
904 Scheduler (1) Start Time 0:00:00
905 Scheduler (1) Start Day 0 (1=Monday)
906 Scheduler (1) Start Week 1,2,3,4
907 Scheduler (1) Duration 0:00:00
908 Scheduler (2) Start Time 0:00:00
909 Scheduler (2) Start Day 0 (1=Monday)
910 Scheduler (2) Start Week 1,2,3,4
911 Scheduler (2) Duration 0:00:00
912 Scheduler (3) Start Time 0:00:00
913 Scheduler (3) Start Day 0 (1=Monday)
914 Scheduler (3) Start Week 1,2,3,4
To Next Page
Loading...
Need help?
General
