wc_tx004457gb_FM10.fm
83
LTV General Maintenance
7.7 Removing and Replacing Lamps
Requirements
■ Engine shut down
■ Light circuit breakers turned OFF
■ Lamps and fixtures cool to the touch
■ Eye and hand protection
This procedure continues on the next page.
WARNING
Burn hazard. Lamps become extremely hot in use.
► Allow lamps and fixtures to cool 10–15 minutes before handling.
WARNING
Personal injury hazard. Ultraviolet radiation from the lamps can cause serious skin
and eye irritation.
► Use only undamaged lamps.
► Use the lamps only with undamaged original equipment lenses and fixtures.
WARNING
Explosion hazard. Grease or oil residue on the lamp can cause the outer jacket to
burst or shatter. Hot flying glass particles can cause personal injury, property
damage, burns, or fire.
► Do not operate the lights with a lens that is cracked, damaged, or missing.
► Do not scratch the lamp or subject the lamp to excess pressure.
► Wear eye and hand protection when removing or replacing lamps.
To Next Page
Loading...
Need help?
General
