wc_tx004458gb_FM10.fm
87
Engine Maintenance: Kubota D1005 / D1105
8 Engine Maintenance: Kubota D1005 / D1105
The information in this chapter comes from copyrighted Kubota material.
The viscosity of the engine oil is an important factor when determining the correct
engine oil to use in your machine. Use an engine oil of appropriate viscosity based
on the expected outside air temperature. See the table below.
WARNING
Most used liquids from this machine such as oil, gasoline, grease, etc., contain
small amounts of materials that can cause cancer and other health problems if
inhaled, ingested, or left in contact with skin for prolonged periods of time.
► Take steps to avoid inhaling or ingesting used liquids.
► Wash skin thoroughly after exposure to used liquids.
temperatures as shown below:
Recommended API classification
Oil used in the engine should have API classification and Proper SAE Engine Oil according to the ambient
Above 25°C (77°F) SAE30, SAE10W-30 or 15W-40
EGR: Exhaust Gas Re-circulation
SAE10W-30 or 15W-40
Below -10°C (14°F)
-10 to 25°C (14°F to 77°F)
Fuel type
SAE10W-30
Engine oil classification (API classification)
Engines with external EGR
Engines with non-EGR
Engines with internal EGR
High Sulfur Fuel
[0.05 % (500 ppm)
Sulfur Content <
0.50 % (5000 ppm)]
---
Ultra Low Sulfur Fuel
[Sulfur Content <
0.0015 % (15 ppm)]
CF, CF-4, CG-4, CH-4 or CI-4
CF
(If the "CF-4, CG-4, CH-4 or CI-4" engine oil is used
with a high-sulfur fuel, change the engine oil at
shorter intervals. (approximately half))
CF or CI-4
(Class CF-4, CG-4 and CH-4 engine, oils
cannot be used on EGR type engines.)
Refer to the following table for the suitable American Petroleum Institute (API) classification of engine oil according
to the engine type (with internal EGR, external EGR or non-EGR) and the Fuel Type Used : (Ultra Low Sulfur or
High Sulfur Fuels).
770030
To Next Page
Loading...
Need help?
General
