wc_tx003254gb_FM10.fm
30
Maintenance P35A
5 Maintenance
5.1 Maintaining the Emission Control System
For machines sold in North America:
Normal maintenance, replacement, or repair of emission control devices and
systems may be performed by any repair establishment or individual; however,
warranty repairs must be performed by a dealer/service center authorized by
Wacker Neuson. The use of service parts that are not equivalent in performance
and durability to authorized parts may impair the effectiveness of the emission
control system and may have a bearing on the outcome of a warranty claim.
5.2 Periodic Maintenance Schedule
The table below lists basic engine maintenance. Tasks designated with check
marks may be performed by the operator. Tasks designated with square bullet
points require special training and equipment.
Refer to the engine manufacturer’s owner’s manual for additional information.
Daily
before
starting
After
first
10 hours
Every
50
hours
Every
100
hours
Check fuel level.
Check engine oil level.
Inspect air filter. Replace as needed.
Change engine oil.
Clean air cleaner.
Clean sediment cup.
Check and clean spark plug.
To Next Page
Loading...
Need help?
General
