wc_tx003254gb_FM10.fm
33
P35A Maintenance
5.5 Spark Plug (Wacker Neuson/Honda)
Clean or replace the spark plug as needed to ensure proper operation. Refer to
your engine owner’s manual.
Note: Refer to section “Technical Data” for the recommended spark plug type and
the electrode gap setting.
1. Remove the spark plug and inspect it.
2. Replace the spark plug if the insulator is cracked or chipped.
3. Clean the spark plug electrodes with a wire brush.
4. Set the electrode gap (a).
5. Tighten the spark plug securely.
NOTICE: A loose spark plug can become very hot and may cause engine damage.
WARNING
Hot surface hazard. The muffler becomes very hot during operation and remains
hot for a while after stopping the engine.
► Do not touch the muffler while it is hot.
To Next Page
Loading...
Need help?
General
