RS 800 /... Operation
wpm_tx001253gb.fm 21
4.7 To Start (RSS 800A)
See Graphic: wc_gr003472
4.7.1 Open the fuel valve by moving the lever to the right (a1).
Note: If the engine is cold, move the choke lever to the closed position
(b1). If the engine is hot, set the choke to the open position (b2).
4.7.2 Open the throttle by moving it slightly to left (d2).
4.7.3 Turn and hold the keyswitch in the “START” position (c2) to start the
engine.
DO NOT hold the keyswitch in the “START” position for more than five
seconds. Damage to the starter may result.
Note: If the engine does not start within five seconds, turn the
keyswitch to “OFF”, wait ten seconds, then turn the keyswitch to
“START” again.
4.7.4 When the engine starts, release the keyswitch and allow it to return to
the “ON” position (c1)
4.7.5 Open the choke (b2) as the engine warms.
4.7.6 Place the throttle in the full open position (d3) to operate.
4.8 To Stop (RSS 800A)
See Graphic: wc_gr003472
4.8.1 Reduce the engine RPM to idle by moving the throttle lever completely
to right (d1).
4.8.2 Turn the keyswitch to the “OFF” position (e2).
4.8.3 Close the fuel valve by moving the lever to the left (a2).
CAUTION
d1
d2
wc_gr003472
a2
a1
b1
b2
d1
d3
c3
c1
c2
To Next Page
Loading...
Need help?
General
