Maintenance RS 800 /...
wpm_tx001254gb.fm 34
5.10 Scraper Bars
See Graphic: wc_gr003476
Check the two scraper bars (a) for wear. Scraper bars are made of
synthetic materials which can wear very quickly when used with
abrasive materials. Replace scraper bars as needed.
Cleaning the scraper bars:
The scraper bars should be cleaned daily after use or as often as
needed to remove built-up dirt, mud, and tar.
Use a high-pressure water jet and a strong brush if needed.
5.11 Cleaning the Machine
When pressure washing the machine, avoid using harsh chemicals
and only use moderate water pressure (500–1000 psi).
Avoid direct pressure to the following components:
• Engine
• Hoses
• Labels
wc_gr003476
a
To Next Page
Loading...
