RS 800 /... Maintenance
wpm_tx001254gb.fm 27
5.3 Lubrication
See Graphic: wc_gr003494
Check the oil level in the hydrostatic drive (a) when the machine is
cold. Fill the reservoir as needed with SAE 10W-30 hydraulic oil.
Check the oil level in the gear case every 100 hours of operation. Fill
the gear case with SAE 90W gear lube as needed through the fill plug
(b). Fill the gear case until the oil is level with the fill plug. When
changing the oil, use the drain plug (f) to drain the oil.
Lubricate the drum bearings (c) every 100 hours of operation. Use a
quality wheel bearing grease. Add 2–3 shots of grease with a hand-
held grease gun. Do not over grease.
Machine
Daily
before
starting
Every
50
hrs.
Every
100
hrs.
Every
300
hrs.
Check external hardware.
Clean battery terminals (RSS 800A)
Check/adjust belt tension.
Check oil level in gear case.
Grease exciter bearings.
Grease drum bearings.
Grease clutch bearing.
Check and adjust scraper bars.
Check oil in hydrostatic transmission
Check shock mounts; replace if cracked or
split.
Change oil in gear case.
To Next Page
Loading...
Need help?
General
