Wacker Neuson WM 90

Reassembly Procedures WM 90 Repair
wc_tx000389gb.fm 60
8.8 Installing Main Bearing Cover
See Graphic: wc_gr001907
8.8.1 Lubricate the oil seal and bearing surfaces with engine oil.
8.8.2 Coat the mating surfaces of the main bearing cover (a) and crankcase
(b) with Loctite
®
515 Gasket Eliminator or equivalent.
8.8.3 Using nine M6 x 30 bolts and washers (c) secure the main bearing
cover to the crankcase. Tighten bolts in pattern shown on illustration.
Torque the bolts to: 9.8–11.8 Nm (7.2–8.7 ft.lbs.).
wc_gr001907
b
a
c
1
2
3
4
8
9
5
6
7