If material isn’t flowing
properly after clearing
these things see
additional instructions in
the Fix Spraying Problems
section
Page 22
Common
Solutions to
Spraying Issues
Keep material owing smoothly while
spraying
Straining material when loading hopper helps
minimize clogging
If experiencing issues with spray patterns
or if material isn’t flowing smoothly follow
instructions to clear the following:
Filter
Spray Tip
If using thicker material the tip may become
clogged. Follow Clear the Spray Tip Instructions
on page 13
Inlet Filter
The inlet lter located in
the hopper is more likely to
clog with thick material or if
something like a leaf gets in the
hopper, follow Clean the Inlet
Filter instructions on page 14
Spray Gun Filter
When using thicker material the lter may
become clogged follow Clean the Spray Gun
Filter instructions on page 15
Spray Tip
Inlet Filter
Solutions if Experiencing Spray Issues
Solutions if Experiencing Spray Issues • While You Are Spraying
English
12
To Next Page
Loading...
Need help?
General
