WAGNER 770 - Clean the Spray Gun Filter; Filter Cleaning Procedure

Start
1
Clean the
Spray Gun
Filter
What you’ll need
•Wrench
•Warm, soapy water for latex
material
•Mineral spirits for oil based
materials
•Replacement spray gun lter
(if necessary)
5. Remove lter from housing
9. Reassemble spray gun8. Replace cleaned lter, tapered end rst,
into gun housing. Note: It is important to place
tapered end rst to ensure proper sprayer
operation
7. Inspect
lter for
damage and
replace if rips
are found
IMPORTANT: Never clean
lter by poking with sharp
object.
Perform Pressure
Relief Procedure
Page 7
6. Clean with appropriate
cleaning solution for material
being used; warm, soapy water
for latex material and mineral
spirits for oil based material
3. Pull trigger guard to separate from lter
housing
PULL
4. Unscrew lter housing using
a wrench
2
5 6 987
3 4
English
15
Tips if Experiencing Spray Issues • Clean the Spray Gun Filter
Tips if Experiencing Spray Issues