WAGNER 770 - Getting Material to Flow Prior to Spraying; Priming Procedure

SQUEEZE
l
O
ON
L
O
C
K
What you’ll need
•Scrap material/cardboard
•Drop cloths to protect oors and furnishings from
overspray
Special Note
Don’t let the hopper run empty. If the hopper runs
empty go to page 8 “Load Material” and page 9 “Get-
ting Material to Flow “ and follow the steps as shown
2. Getting
Material to Flow
Prior to Spraying
3. Point spray gun at piece of scrap material/
cardboard. Squeeze and hold trigger for steps
4-6
2. Unlock spray gun by turning
trigger lock down
U
N
L
O
C
K
7. Release trigger and lock
spray gun
6. Continue to squeeze trigger until the material
is owing freely through spray gun
5. Turn knob to SPRAY4. Turn power ON
T
U
R
N
SPRAY
Start
32
1
4 5 6 7
Using the Wagner Paint Crew
English
9
Using the Wagner Paint Crew • Getting Material to Flow Prior to Painting