ON
OFF
2-3 MINUTES
3. Remove inlet lter and clean with appropriate cleaning solution.
Replace inlet lter in hopper
9. Hold material return tube
over a waste container. Run for
2 to 3 minutes
10. Turn power OFF
7. Turn knob to PRIME
8. Turn power ON
4. Partially ll hopper with
NEW cleaning solution
2. Rinse hopper with appropriate cleaning
solution
What you’ll need
• Warm, soapy water
• Mineral spirits if using oil-
based material
• Rags
Start
Clean the Hopper
INLET
FILTER
T
U
R
N
11. Properly dispose of
cleaning solution in hopper
Note: If mineral spirits were
used to clean hopper repeat
clean hopper instructions using
warm, soapy water
or
5. Remove material return
tube from hopper
6. Hold tube over waste
container
Do not allow any uid to drip
onto the motor housing.
3
97
10
4
2
1
8
115
6
English
19
Cleanup and Storage • Clean the Hopper
Cleanup and Storage
To Next Page
Loading...
Need help?
General
