WAGNER AC 4600 - Finishing Work and Cleaning

25
AC 4600 Pro
OPERATING MANUAL
EDITION 02/2009
PART NO. DOC394871
Note:
Methylene chloride is not recommended as a fl ushing or cleaning solvent with this gun or
any system components.
1. Relieve spray gun and unit pressure.
2. Secure gun with trigger safety catch.
3. Connect cleaning supply.
4. Remove AirCoat -jet nozzle and clean separately (see chapter 5.4.3).
5. Pressurize the cleaning supply to approx. 4 MPa; 40 bar; 580 psi and thoroughly fl ush
the spray gun.
6. Relieve spray gun and unit pressure.
7. Secure gun with trigger safety catch.
8. Clean gun body with a cleaning agent recommended by the manufacturer, and dry
with a cloth.
6.1 FINISHING WORK AND CLEANING
DANGER
Exploding gas/ air mixture!
Danger to life from flying parts and burns
Never spray into a closed container.
Earth the container.
SIHI_0008_GB
CAUTION
Cleaning agent in the air duct!
Functional faults caused by swollen seals
Always point the spray gun down when cleaning.
Ensure that neither paint nor cleaning agent enters the air duct.
SIHI_0005_GB

7!2.).'
%XPLOSIVEATMOSPHERE
%XPLOSIVEGASESAREPRODUCEDWHENALUMINIUMCOMESINTOCONTACT
WITHHALOGENIZEDHYDROCARBONS
 4OCLEANALUMINIUMDONOTUSELIQUIDSCONTAININGHALOGENIZED
HYDROCARBONS
3)()??'"